When the plans have been approved by you or your authorized representative and all necessary permits have been obtained, the construction process may begin. Our representative will go over the construction stages with you and help to set the pool elevation. Next, the form boards are set with great care to ensure the pool is in the exact location required.
After the forms are set, the excavation of the pool may begin. We generally use small, skid-steer front end loaders in order to precisely trim back the pool walls and to provide added maneuverability within the pool and around the construction site.
The pool shell is reinforced with Grade 60 #3 steel rebar, placed horizontally and vertically. The horizontal and vertical bars are placed 8″ on center to a depth of five feet. If the depth of the pool exceeds five feet, the horizontal bars are placed at 6″ on center. The beam has 4 bars of #4 rebar.
Rough plumbing, or “stub out” is done immediately following steel installation. This entails the installation of main drains, skimmers, light niches, return line “stubs” and pre-plumbing of raised spas.
Pool Floor and Gunite Application
The pool floor consists of concrete with a compressive strength of 4000 psi, and is a minimum thickness of six inches. The walls of the pool consist of a mixture of sand and cement (gunite) that is applied through a hose with highly pressurized air to achieve a compressive strength of 4000 psi. Because of its superior structural strength, we provide a two year warranty on the pool shell after completion.
Tile and Coping
After the completion of the gunite phase, you will be asked to choose a decorative tile for the pool. We have a selection of over 150 different tiles for you to choose from. No matter what colors, textures and materials are being used for the project, we will have something to fit your taste.
The plumbing for each pool is designed specifically to give it the best circulation and filtration for crystal clear water and ease of maintenance. We perform hydraulic calculations to ensure that all equipment and piping are of the correct size to combine water clarity and energy conservation.
An experienced installer will come to the site and plumb in all of the filtration equipment for the pool, including water feature pumps and other optional equipment from Pentair.
Electrical and Gas
By this point, electrical conduits for pool lights and for pool equipment power should be run. The breaker box at the location of the pool equipment should be installed and ready for the equipment to be set. Gas lines to the pool heater or heaters should also be run to the equipment location. These operations should be handled by a licensed electrician/utility specialist.
Deck Layout and Pour
The pool deck should reflect the overall theme for the project, including color, pattern and type. Typically, the deck at the pool edge is shaped using a rounded cantilever foam form for comfort and safety. Pool coping such as brick and stone are also available to compliment the other materials used on the job. The deck is a minimum of four inches thick and reinforced with steel rebar approximately 18” on center. In most cases, any stone or brick work should be completed before the decking is poured.
Site Clean Up
At this point, the project is nearing completion. We will now remove all extraneous construction materials and waste from the construction site and prepare the pool interior to be finished.
The pool interior is coated with your choice of materials, from a standard white finish, or one of the many Pebble Tec finish, or one of the many Diamond-Brite brand coatings. Different finishes render different effects and moods upon the pool water and therefore the overall appearance of the backyard area. When the coating is finished, we begin filling the pool with water. This should be the final stage of construction.